大发平台大全网站-大发welcome登录入口

山东山汽工程机械(集团)有限公司
热线电话:400-879-1999 山汽官方微信
郑重声明 购机 售后
热线电话:400-879-1999
您现在所在的位置: 首页> 大发平台大全网站 > 公司新闻 >

自动上料搅拌车操作时需要注意几个要点

所属分类:公司新闻 发布时间:2022-05-23 来源: 浏览量:18

操作是注意几个要点
Operation is to pay attention to several key points
1、在混凝土搅拌车作业前需进行检查,确认转向、制动、灯光、信号系统灵敏有用,搅拌运输车滚筒和溜槽无裂纹和严重损伤,搅拌叶片磨损在正常范围内,底盘和副车架之间的U形螺栓连接良好。
1. Before the operation of the concrete mixer truck, it is necessary to check to confirm that the steering, braking, lighting and signal systems are sensitive and useful, the drum and chute of the mixer truck are free of cracks and serious damage, the wear of the mixing blades is within the normal range, and the U-shaped bolts between the chassis and the subframe are well connected.
2、了解施工要求和现场情况。选择行车路线和停车地点。
2. Understand the construction requirements and site conditions. Select the route and parking place.
3、在社会道路上行驶需遵守交通规则。转弯半径应符合使用说明书的要求,时速不大于15km。进站时速不大于5km。
3. Traffic rules shall be observed when driving on social roads. The turning radius shall meet the requirements of the operation manual, and the speed shall not be greater than 15km per hour. The entry speed shall not be greater than 5km per hour.
4、作业时,严禁用手触摸旋转的滚筒和滚轮。
4. During operation, it is forbidden to touch the rotating drum and roller by hand.
5、在混凝土搅拌车倒车卸料时,需服从指挥,注意周围人员,发现异常立即停车。
5. When reversing the concrete mixer truck for unloading, obey the command, pay attention to the surrounding personnel, and stop immediately in case of abnormalities.
6、严禁在高压线下进行混凝土搅拌车清洗作业。
6. It is strictly prohibited to clean the concrete mixer truck under the high-voltage line.
6、日常维护
6. Routine maintenance
由于混凝土会在短时间内凝固成硬块,且对钢材和油漆有一定的腐蚀性,所以每次使用混凝土贮罐后,洗净粘附在混凝土贮罐及进出料口上的混凝土是每日维护需认真进行的工作。其中包括:
Since the concrete will solidify into hard blocks in a short time and have a certain corrosivity to steel and paint, cleaning the concrete adhered to the concrete storage tank and the inlet and outlet after each use of the concrete storage tank is a serious work for daily maintenance. These include:
a.每次装料前用水冲洗进料口,使进料口在装料时保持湿润;
a. Wash the inlet with water before loading each time to keep the inlet moist during loading;
b.在装料的同时向随车自带的清洗用水水箱中注满水;
b. Fill the cleaning water tank with water while loading;
c.装料后冲洗进料口,洗净进料口附近残留的混凝土;
c. Wash the inlet after loading and clean the residual concrete near the inlet;
d.到工地卸料后,冲洗出料槽,然后向混凝土贮罐内加清洗用水30—40 L;在车辆回程时保持混凝土贮罐正向慢速转动;
d. After unloading at the construction site, wash the discharge tank, and then add 30-40 l of cleaning water to the concrete storage tank; Keep the concrete storage tank rotating forward and slowly when the vehicle returns;
e.下次装料前切记放掉混凝土贮罐内的污水;
e. Remember to discharge the sewage in the concrete storage tank before the next loading;
f.每天收工时全部清洗混凝土贮罐及进出料口周围,保证不粘有水泥及混凝土结块。
f. Clean the concrete storage tank and around the inlet and outlet at the end of each day to ensure that there is no cement and concrete caking.
本文的精彩内容由提供知识提供,本网站还有很多的精彩内容,更多的内容您可以点击进入:我们有专门的客服为您解答问
The wonderful content of this article is provided by the knowledge of automatic feeding mixer. There are many wonderful contents on this website. You can click to enter more contents: http://www.sqjituan.com We have special customer service to answer your questions
热门产品 / HOT PRODUCT

 

首页 产品 电话 置顶
Baidu
sogou